S5-47 Manual Trans for Ford 1999 F-series 5.4L & 6.8L 4×4, 5 Speed

Description

Across grueling 12-hour winter municipal shifts demanding continuous snow plow operations and severe utility trailer towing, internal gearsets hold 470 lb-ft torque without slip inside the ZF S5-47 Remanufactured Manual Transmission engineered for 1999 Ford Super Duty F-Series four-wheel drive work trucks powered by 5.4-liter V8 and 6.8-liter V10 engines.

Cast aluminum housing architecture incorporates modular Ford bell housing bolt patterns to match 5.4-liter V8 and 6.8-liter V10 power plants. Multi-cone brass synchronizers on forward gears halt gear clash during low-range off-road shifting. The four-wheel drive rear extension housing mates straight to New Venture transfer cases. Bare package dry weight registers 175 lbs. Fluid capacity holds 3.4 quarts of synthetic Mercon ATF fluid circulating past magnetic inspection plugs.

Key Features of ZF S5-47

Four-wheel drive fleet operators choose to buy ZF S5-47 remanufactured transmission units to eliminate gear jumping and bearing failure in severe off-road work environments. Specialized remanufacturing brings all internal clearances back to original factory specifications for dependable commercial operation.

• Modular Ford bell housing pattern bolts straight to 5.4L and 6.8L engine blocks.
• Carbon-composite synchronizers prevent gear clash during low-range transfer case engagement.
• Massive helical cluster gears absorb 470 lb-ft continuous input engine torque.
• Hardened shift rails and detent springs stop transmission jumping out of gear.
• High-capacity tapered roller bearings hold shaft endplay within strict factory limits.
• Four-wheel drive adapter housing bolts straight to Super Duty transfer cases.
• Tested ZF S5-47 gearsets guarantee quiet gear mesh across all speed ranges.
• High-temp Viton transfer case adapter seals prevent cross-fluid contamination.

Modular Four-Wheel Drive Gearing Capacities

The 5-speed manual gear set provides wide ratios featuring 5.72:1 in first, 2.94:1 in second, 1.61:1 in third, 1.00:1 in fourth, and 0.76:1 in fifth gear overdrive. Continuous duty designation supports up to 470 lb-ft continuous input torque at 2,400 RPM. The ultra-low 5.72:1 first gear provides crawl capability across steep rock and mud job sites. External housing cooling fins radiate heat to hold lubricant sump temperatures below 180°F under heavy gross combined vehicle weights.

Modular Transfer Case Spline Dimensions

A 10-spline 1.25-inch diameter input shaft slides flush into standard modular clutch plates without binding. The four-wheel drive 31-spline output shaft interfaces straight with transfer case input hubs. Centerline shaft runout measures under 0.002 inches on dial indicators to protect transfer case input bearings from premature failure during heavy torque transfers.

Super Duty Manual Gearbox Protocols

Check clutch hydraulic master and slave cylinder stroke to ensure complete clutch plate disengagement before initial road testing. Fill the transmission case using synthetic Mercon ATF fluid through the side check port. This unit is not engineered for closed-course drag strip racing, extreme rock crawling, or gross combined vehicle weights exceeding factory chassis tow limits.

• Inspect transfer case adapter housing seals for fluid seepage each shift.
• Drain transmission fluid, clean magnetic drain bungs, and refill every 30,000 miles.
• Inspect four-wheel drive shifter linkage bushings and crossmember bolts every 12 months.

Super Duty Crate Warranty Terms

Protected by an industry-leading 3-Year / 100,000-Mile commercial fleet warranty covering certified parts and labor. Each heavy wooden shipping crate contains one remanufactured manual transmission, sealed PTO block-off plate, new throwout bearing, transfer case gasket, installation manual, and signed rotational inspection report.