6F35 2017-2020 Ford Fusion 1.5L FWD – Remanufactured 6-Speed Automatic Trans

Description

Developed for efficient midsize sedans, this Ford Fusion 1.5L 2017-2020 Remanufactured Transmission channels 1.5L EcoBoost turbo power straight to the front wheels. The 6-Speed FWD platform supports 181 horsepower and 185 lb-ft of torque beneath a 6,000 RPM ceiling. Working hydraulic line pressure peaks at 215 PSI to prevent clutch slippage across spirited highway gear transitions.

A thick cast aluminum transaxle case encloses carburized 8620 steel helical gear sets and an integrated front differential. Segmented graphite friction plates pair with nitrided steel reaction separator plates to resist clutch glazing. The remanufactured valve body features hardened steel sleeves and an oversized mainline pressure regulator spool. Dry unit weight measures 176 lbs, supporting an 8.2-quart fluid capacity with 3/8-inch threaded cooler ports.

Key Features of Ford Fusion

Commercial fleet operators buy Ford Fusion 2017-2020 remanufactured transmission inventory to cure delayed forward gear engagement and eliminate torque converter clutch slip in EcoBoost sedans. Upgraded internal mechanical parts provide dependable power transfer under continuous highway and urban driving conditions.

• 24-spline turbine input shaft connects straight into the balanced lockup torque converter.
• Fusion 2017-2020 replacement valve body stops internal pressure loss during rapid ratio changes.
• 6 forward gear ratios balance sharp off-the-line launch power with quiet highway cruising.
• Precision-ground helical gear sets minimize gear hum across all vehicle operating speeds.
• 2017-2020 Fusion gear train module features heat-treated planet carriers for torsional rigidity.
• Nitrided clutch reaction plates prevent heat coning under repeated wide-open throttle acceleration.
• Pulse-width modulated shift solenoids maintain rapid clutch application across cold and hot temperatures.

Fusion EcoBoost Transaxle Flow Bounds

Operating hydraulic circuit line pressure holds between 175 and 215 PSI via electronic pressure regulator solenoid modulation. Sump oil temperatures remain within 168°F to 192°F during continuous high-speed transit. Forward gear reduction steps from a 4.58:1 1st gear ratio down to a 0.70:1 6th gear overdrive, lowering cruising engine speed and cabin drone. High-flow internal oil channels direct continuous fluid volume through external cooling radiators to stop transmission fluid breakdown during summer heat.

Sedan CV Axle Spline Centering

The front transaxle casing houses twin precision-machined drive axle outputs engineered for factory half-shaft CV joints. Dial indicator measurements confirm differential bearing radial runout remains under 0.0015 inches. The chassis crossmember mounting pad rests exactly 15.2 inches from the engine block mating plane. Factory pilot dowels guarantee centered installation and prevent high-speed driveline harmonics.

Sedan Transaxle Bench Testing

Automated dyno testing evaluates each transmission with heated synthetic fluid under road resistance loads to certify shift solenoid timing and clutch pack holding pressure across all gears. This transmission is not engineered for drift track racing, forced-induction turbo conversions, or drivelines with restricted fluid cooler lines.

• Check transmission pan fluid level through inspection port every 30 operating days.
• Renew synthetic automatic transmission fluid and internal pan filter every 30,000 miles.
• Inspect CV drive axle seals and subframe mount bushings every 12 months.

Fusion EcoBoost Crate Terms

Fleet operators receive an ironclad 3-Year unlimited mileage warranty protecting against mechanical defect. The heavy wooden transport container holds the remanufactured 6-Speed FWD transaxle, dyno-verified torque converter, replacement output seal hardware, and technical transmission fluid specification documents outlining proper refill procedures.