Chevy 1.4 Turbo Engine 2014-2019 Cruze, Encore, Sonic, Trax
Description
Prevent turbocharger wastegate arm wear, eliminate cracked piston land blow-by, and hold 45 PSI hot cruise oil pressure across demanding metropolitan multi-stop commercial courier routes with the Chevy 1.4L Turbo Ecotec Remanufactured Engine engineered for 2014 to 2019 Chevrolet Cruze, Sonic, and Buick Encore commercial vehicles. This cast iron DOHC turbo platform restores high fuel economy and dependable multi-shift service.
Manufactured with a high-density cast iron block with deep skirts, this 1.4-liter engine casting halts bore distortion under continuous turbo boost. A micro-polished forged steel crankshaft turns within tri-metal bearings, linked to forged powdered metal connecting rods and graphite-coated hypereutectic aluminum pistons with dish crowns. Decks receive an Ra 30 finish for MLS gasket sealing. Dry weight registers at 245 lbs with a 4.2-quart capacity stamped steel oil pan.
Key Features of Chevy 1.4L Turbo Ecotec
Metropolitan fleet operators buy Chevy 1.4L Turbo Ecotec remanufactured engine packages to lower vehicle maintenance expenses and keep urban couriers on schedule. Each rebuilt long block undergoes automated cold-test spin verification to confirm proper oil gallery pressurization before distribution.
- Piston cooling oil squirt jets spray cylinder crowns to suppress detonation under boost
- Dual continuous variable valve timing phasers optimize intake and exhaust camshafts under load
- 0.0010 to 0.0017 inch main bearing clearances maintain solid hydrodynamic lubrication film strength
- Multi-layer steel cylinder head gaskets maintain combustion seals across extreme summer boost heat
- High-flow internal trochoid oil pumps channel pressurized lubricant to turbocharger bearings and camshafts
- Induction-hardened valve seats prevent valve face recession during continuous city stop-and-go driving
- Precision rotating package balancing protects Chevy 1.4L Turbo Ecotec driveline parts from vibration
Ecotec 1.4L Turbo Operational Limits
Operating lubricant pressure produces 18 to 22 PSI during warm idle and expands to 45 through 60 PSI at 2800 RPM cruise speeds. Internal coolant temperatures stabilize between 195°F and 210°F through regulated cross-flow cooling circulation. This 1.4-liter turbocharged engine generates 138 horsepower at 4900 RPM and 148 lb-ft continuous torque at 1850 RPM with a 9.5:1 compression ratio. Cylinder cranking pressure measures between 170 and 185 PSI across all four chambers. The cooling system rejects 2200 BTU per minute during loaded highway transit.
Ecotec 1.4L Crankshaft Transaxle Alignment
A 6-bolt rear crankshaft flange mounts flush to factory 6T40 automatic transaxle flexplates or manual flywheels. Measured crankshaft thrust endplay checks out between 0.0030 and 0.0070 inches. The 0.984-inch front crankshaft snout features a single keyway to position the timing chain sprocket and harmonic balancer, holding true accessory drive belt pulley alignment.
Ecotec 1.4L Fleet Servicing Protocols
Technicians must prime the engine oil pump prior to first startup by cranking the starter without ignition until oil pressure warning lamps extinguish. Fill the crankcase with 5W-30 full synthetic motor oil meeting GM dexos standards. This production engine is not engineered for turbo upgrades exceeding 16 PSI boost, nitrous injection, or competitive drag racing.
- Check crankcase oil level and coolant tank fluid volume each shift before driving
- Drain break-in motor oil and install fresh oil filter after 500 initial miles
- Perform routine oil and filter changes every 3500 miles during commercial transit cycles
Ecotec 1.4L Commercial Warranty Manifest
Commercial fleet purchasers receive a 3-Year / 100,000-Mile commercial fleet warranty covering structural casting and internal moving components. The heavy-duty wood crate contains one remanufactured long block engine, a complete engine install gasket set, spark plug well seals, front timing cover seals, dyno test documentation, and priming instructions.
Chevy 1.4 Turbo Engine 2014-2019 Cruze, Encore, Sonic, Trax Additional Info
| Weight | 440 lbs |
| Dimensions | 38 × 38 × 38 in |
| Q | Long Block Engine Only with gaskets |
| Engine VIN Code | B |
| Fuel Type | Gasoline or Flex Fuel |
| Displacement | 1.4L |
| Number of Cylinders | 4 |
| Product Type | Engines |
| Block Type | Inline 4 |
| Head Type | DOHC |
| Number of Valves | 16 |
Chevy 1.4 Turbo Engine 2014-2019 Cruze, Encore, Sonic, Trax Vehicle Fitment
| Year | Make | Model | Engine | Note |
|---|---|---|---|---|
| 2011 - 2015 | Chevrolet | Cruze | L4 1.4L 1364cc | In-Line Head Cast # 55573669, Block Cast # 55577377, 25198821, Dual V.V.T., Timing Cover Cast #55562788, 5 Groove Front Pulley Installed, #2 dsctn 3/19/24 |
| 2012 - 2020 | Chevrolet | Sonic | L4 1.4L 1364cc | In-Line Head Cast # 55573669, Block Cast # 55577377, 25198821, Dual V.V.T., Timing Cover Cast #55562788, 5 Groove Front Pulley Installed, #2 dsctn 3/19/24, 5 Groove Pulley Installed |
| 2013 - 2020 | Chevrolet | Trax | L4 1.4L 1364cc | In-Line Head Cast # 55573669, Block Cast # 55577377, 25198821, Dual V.V.T., Timing Cover Cast #55562788, 5 Groove Front Pulley Installed, #2 dsctn 3/19/24 |
| 2013 - 2021 | Buick | Encore | L4 1.4L 1364cc | In-Line Head Cast # 55573669, Block Cast # 55577377, 25198821, Dual V.V.T., Timing Cover Cast #55562788, 5 Groove Front Pulley Installed, #2 dsctn 3/19/24, 5 Groove Pulley Installed |
| 2016 - 2016 | Chevrolet | Cruze Limited | L4 1.4L 1364cc | In-Line Head Cast # 55573669, Block Cast # 55577377, 25198821, Dual V.V.T., Timing Cover Cast #55562788, 5 Groove Front Pulley Installed, #2 dsctn 3/19/24 |
You must be logged in to post a review.










Reviews
There are no reviews yet.