Vetus GLX20TIC 20kVA Marine Diesel Generator Package

Description

Heavy cast iron block metallurgy anchors the Vetus GLX20TIC Marine Generator Package. Displacing 2.505 liters across four cylinders, this marine diesel power plant outputs 16.0 kW continuous three-phase power with 20.0 kVA peak capacity at 1,500 RPM. Built with a 400-volt 50 Hz winding inside an acoustic capsule, it sustains commercial walk-in freezers, hydraulic pack pumps, and central chillers without cabin vibration.

Thick-wall cast iron block metallurgy deadens mechanical combustion rumble within confined marine machinery spaces. The rotating group incorporates a forged alloy steel crankshaft, forged connecting rods, and oil-cooled aluminum pistons. Engine geometry measures an 88 mm cylinder bore, 103 mm stroke, 22:1 compression ratio, 8.0-quart oil sump capacity, and dry net weight of 920 lbs inside its sound shield. Splayed main bearing caps reinforce lower case rigidity under heavy loads.

Key Features of Vetus GLX20TIC

Commercial mariners buy Vetus GLX20TIC generator packages to achieve dependable three-phase power inside large working hulls. This 50 Hz power unit outputs balanced 400-volt alternating current to eliminate phase imbalances across heavy machinery spaces.

• 16.0 kW continuous 400-volt three-phase output supports heavy induction motor starts without voltage sag.
• Four-pole brushless alternator design uses solid-state regulation to hold line voltage variation within one percent.
• Sealed acoustic housing keeps machinery noise restricted to 54 decibels at seven meters distance.
• GLX20TIC marine generator electronic monitoring system triggers immediate engine shutdown upon fault detection.
• Oversized cupronickel heat exchanger maintains low engine coolant temperatures during full-load summer runs.
• Water-cooled cast iron exhaust elbow isolates heat radiation from composite fiberglass engine beds.
• Central service layout places dipsticks, oil filters, and the sea water pump behind one quick-release door.

Three Phase Alternator Output Verification

Turning at a governed 1,500 RPM, this four-stroke diesel delivers clean 50 Hz electrical power across marine switchboards. Continuous three-phase output yields 16.0 kW (20.0 kVA at 0.8 power factor) across 400-volt circuits. Measured fuel burn records 1.15 gallons per hour at half load and 1.95 gallons per hour at full continuous rating. Pressurized internal lubrication galleries sustain 35 to 55 PSI hot oil pressure, shielding journals.

Engine Bed Machinery Clearances

Outer dimensions measure 1,280 mm long, 640 mm wide, and 720 mm high within its heavy sound enclosure. Four captive marine mounts detach engine harmonics from stringer frames. The 2-inch wet exhaust fitting requires direct fall to waterlock silencers, and side panels require six inches of technician working room.

Diesel Generator Service Maintenance Rules

Purge air from fuel injection passages using the manual primer arm before engaging the electric starter. Fill freshwater cooling loops with approved marine coolant to prevent localized hot spots. This unit is not engineered for dry land exhaust operation, raw sea water block circulation, or unventilated bilge spaces.

• Drain factory break-in lube oil and install fresh filter elements after the first 50 operating hours.
• Inspect flexible raw water pump impellers and drain fuel sediment bowls every 200 running hours.
• Clean cupronickel heat exchanger tubes and replace sacrificial zinc anode plugs every 12 months.

Marine Warranty Pack Manifest

Vetus supports this generator with a 24-Month limited commercial marine warranty. The wooden freight crate contains the complete generator unit, sound attenuation enclosure, remote digital control panel, flexible fuel line kit, factory load test printout, and technical operator service documentation binder.