Lombardini LMG6000 5kW 6kVA Single Phase 50Hz Marine Diesel Generator

Description

Eliminate auxiliary boat battery charging deficits with the Lombardini LMG6000 Marine Diesel Generator. Displacing 0.505 liters across two in-line cylinders, this marine diesel power plant outputs 5.0 kW continuous single-phase power with 6.0 kVA peak capacity at 3,000 RPM. A digital electronic governor combines with freshwater heat exchanger cooling to sustain cabin air conditioning chillers, water heaters, and galley refrigeration without frequency droop.

A compact cast iron two-cylinder block provides structural mass to attenuate mechanical vibration across composite yacht hulls. The internal rotating group features a drop-forged alloy steel crankshaft, forged connecting rods, and oil-cooled aluminum pistons. Engine geometry measures a 72 mm cylinder bore, 62 mm stroke, 22.8:1 compression ratio, 1.8-quart oil capacity, and dry net weight of 286 lbs inside its sound shield. Symmetrical crankcase webbing prevents structural distortion.

Key Features of Lombardini LMG6000

Express cruiser owners buy Lombardini LMG6000 generator packages to modernize obsolete auxiliary engines inside cramped mid-cabin spaces. This 50 Hz package generates clean alternating current to run cabin comforts without battery bank exhaustion.

• 5.0 kW continuous 230-volt single-phase output maintains salon cooling and galley refrigeration without generator strain.
• Synchronous brushless alternator design eliminates commutator brush maintenance while stabilizing total harmonic distortion.
• Acoustic sound housing suppresses internal combustion noise down to 54 decibels at seven meters distance.
• LMG6000 marine diesel generator digital control board monitors exhaust temp, oil pressure, and raw water flow.
• Cupronickel tube-and-shell heat exchanger shields internal cast iron block passages from direct raw seawater contact.
• Single-side service design clusters fluid dipsticks and spin-on filters behind one fast-release latching panel.
• Water-cooled cast iron exhaust elbow isolates extreme exhaust heat from composite yacht bulkheads.

Alternator Load Dyno Capabilities

Operating at an exact 3,000 RPM governing point, this four-stroke diesel maintains stable 50 Hz current. Full electrical output yields 5.0 kW and 21.7 amps across 230-volt lines. Measured fuel burn records 0.35 gallons per hour at 50 percent load and 0.65 gallons per hour at maximum output. Internal oil galleries maintain 30 to 50 PSI hot pressure, safeguarding main bearing journals from thermal fatigue during extended cruising under full continuous electrical loads.

Bilge Mounting Envelope Dimensions

The compact sound shield measures 670 mm in length, 440 mm in width, and 545 mm in height. Heavy neoprene base mounts absorb secondary hull harmonics. Exhaust plumbing connects to a 1.5-inch water-injected exhaust elbow, while the front and starboard service panels demand five inches of clearance for lube maintenance.

Scheduled Marine Service Rules

Operate the fuel feed priming arm to evacuate air from diesel filter bowls before initial engine start. Maintain full expansion bottle coolant levels to prevent dry heat cycles. This marine unit is not engineered for raw sea water block cooling, open deck installations, or unvented gasoline holds.

• Extract factory run-in oil and renew full-flow filter elements after the initial 50 hours of operation.
• Check raw water pump impeller flexibility and clean fuel separator bowls every 200 running hours.
• Descale heat exchanger core tubes and thread in fresh zinc protection plugs every 12 months.

Pleasure Craft Warranty Manifest

Lombardini includes a comprehensive 24-Month limited warranty on all pleasure craft installations. The reinforced freight crate contains the complete encased generator package, remote digital start panel, isolated vibration mounts, factory run verification printout, and complete owner service manual binder.