Fischer Panda FPMA1002-Generator 8000i PMS, KW/kVA 6.0 / 8.0, 2200-2800 RPM, Cyl. 2, 520 x 440 x 550

Description

During quiet anchorages in secluded coves, the Fischer Panda 8000i PMS Marine Generator produces 6.0 kW continuous electrical output with 8.0 kVA peak capacity. Powered by a two-cylinder diesel engine operating between 2,200 and 2,800 RPM, this inverter generator modulates engine speed to match electrical demand, providing pure sine wave 230-volt current while minimizing fuel consumption.

A compact cast iron two-cylinder block combines with high-grade aluminum cooling jacket housings to reduce installation mass. The reciprocating group incorporates a dynamically balanced forged steel crankshaft, forged connecting rods, and heat-resistant aluminum pistons. Engine geometry measures a 67 mm cylinder bore, 68 mm stroke, 0.479-liter displacement, 1.5-quart oil capacity, and total dry weight of 258 lbs. Total liquid cooling encapsulates both the diesel block and permanent magnet alternator.

Key Features of Fischer Panda 8000i PMS

Cruising sailors buy Fischer Panda 8000i PMS generator packages to achieve lightweight auxiliary power inside restricted sailboat engine compartments. This variable-speed inverter system supplies clean 230-volt energy to power induction stoves and air conditioning without noise pollution.

• 6.0 kW continuous inverter power output produces pure sine wave current for sensitive electronics and laptops.
• Variable speed control adjusts engine speed between 2,200 and 2,800 RPM based on electrical power demand.
• Permanent magnet alternator technology outputs high electrical efficiency within an ultra-compact physical enclosure.
• 8000i PMS marine generator digital control panel monitors inverter status, operational frequency, and battery voltage.
• Dual-circuit liquid cooling circulates freshwater through both the diesel block and stator winding jackets.
• Sound insulation capsule drops operating sound emissions down to 52 decibels at seven meters distance.
• Automatic safety shutdown protocols protect the unit against high winding temperature or low oil pressure.

Variable Speed Inverter Power Verification

Operating across an intelligent 2,200 to 2,800 RPM speed range, this inverter generator sustains flawless 230-volt 50 Hz power output. Continuous load capacity generates 6.0 kW with an 8.0 kVA maximum rating. Fuel consumption records 0.29 gallons per hour at light loads, expanding to 0.58 gallons per hour under continuous full rating. Pressurized internal oil circuits sustain 30 to 50 PSI hot oil pressure, shielding bearing journals while the electronic inverter stabilizes total harmonic distortion below three percent.

Compact Capsule Installation Dimensions

Measuring 520 mm long, 440 mm wide, and 550 mm high, the fiberglass sound capsule slides into narrow under-bunk lockers. Rubber base isolation mounts absorb engine vibrations from thin composite hulls. A 1.5-inch water-cooled wet exhaust connection drops gases overboard, requiring four inches of perimeter clearance for cooling air circulation.

Inverter Generator Marine Service Rules

Prime the low-pressure fuel circuit before initial startup to evacuate entrapped air bubbles. Fill the internal liquid cooling jacket with premixed marine antifreeze to avert thermal hotspots across the stator casing. This inverter package is not engineered for raw sea water block circulation, unvented spaces, or three-phase commercial distribution boards.

• Drain factory run-in oil and install fresh filter canisters after the first 50 operating hours.
• Inspect raw water pump rubber impellers and clean fuel sediment filters every 200 running hours.
• Flush the liquid cooling heat exchanger and replace internal zinc protection plugs every 12 months.

Factory Warranty Crate Contents

Fischer Panda provides a 24-Month limited marine manufacturer warranty on this inverter generator package. The wooden transport crate holds the silenced generator unit, digital remote display station, external power inverter module, flexible mounting feet, factory test protocol report, and technical operator service manual binder.