VEGE 255B 2.0L 121ci Car Truck Long Block Remanufactured Crate Engine

Description

Satisfy strict state commercial tailpipe emissions regulations with the VEGE 255B Remanufactured Crate Engine replacement long block. Displacing 2.0 liters across 121 cubic inches, this inline-four produces 125 horsepower at 5,200 RPM and 130 lb-ft torque. It powers fleet sedans, compact service vehicles, and delivery runabouts demanding low emissions output, restored cylinder compression, and smooth operation on 87-octane pump fuel.

A seasoned cast iron block with five main bearing caps provides structural rigidity against high-mileage cylinder bore distortion. The internal rotating group includes a reground nodular iron crankshaft, balanced steel connecting rods, and 3.31-inch bore hypereutectic pistons producing a 9.2:1 compression ratio. A 3.8-quart wet sump pan manages oiling, holding total dry engine mass at 260 lbs.

Key Features of VEGE 255B

Repair facilities drop this remanufactured four-cylinder directly into fleet vehicles to solve valvetrain noise and poor fuel mileage. Shop foremen who buy VEGE 255B crate engine packages obtain factory-standard replacement long blocks that bolt into original vehicle compartments without installation hurdles.

• 3.31-inch bore hypereutectic pistons resist cylinder bore scuffing during stop-and-go driving cycles
• Reground nodular iron crankshaft journals establish correct oil film clearances across all bearings
• Shot-peened steel connecting rods withstand repeated stress cycles without structural fatigue failures
• Diamond plateau honed cylinder walls ensure rapid ring seat formation and low oil consumption
• Precision-ground valve stems restore tight clearance tolerances inside remanufactured valve guides
• VEGE 255B camshaft lobes maintain original valve timing for smooth idle and low exhaust emissions
• Direct-acting valvetrain bucket tappets reduce moving valvetrain mass and eliminate adjustment drift
• Pressure-tested cylinder block castings eliminate internal porosity between water and oil jackets

Operational Dyno Vacuum Metrics

Testing certifies 125 brake horsepower at 5,200 RPM with 130 lb-ft torque at 3,800 RPM from 1,400 to 5,400 RPM. Factory camshaft geometry provides 0.345-inch valve lift with original duration curves. Operating on standard 87-octane pump gasoline, this unit pulls 18.5 in-Hg manifold idle vacuum and holds 35 to 48 PSI oil pressure when warm.

Transmission Mating Clearance Bounds

Matching original vehicle transaxle bolt patterns, this compact four-cylinder mounts directly to factory automatic or five-speed manual transaxles. Factory engine mount brackets align with original chassis isolators, clearing front crossmembers, steering racks, and radiator assemblies inside compact passenger car engine compartments.

Startup Sequence Operating Limits

Pre-lube the engine with conventional 5W-20 petroleum oil using an external primer before rotating the starter pinion. Completely burp cooling system air pockets to prevent localized cylinder head hot spots. This remanufactured long block is not engineered for performance turbocharging, marine applications, or track racing duty.

• Dump initial break-in engine oil and change filters after the first 500 miles
• Swap motor oil and install fresh spin-on oil filters every 3,000 miles
• Inspect timing belt condition, accessory drive belts, and coolant hoses every 12 months

Warranty Statement Physical Manifest

VEGE covers this long block with a 36-Month / 100,000-Mile remanufactured limited parts warranty. The heavy wooden crate holds the complete remanufactured long block, assembled cylinder head, oil pan, oil pump, timing components, and certified factory inspection sign-off documentation.