4R70W 1996-1997 Ford Mustang 4.6L RWD – Remanufactured 4-Speed Automatic Trans

Description

Engineered for sports coupe performance, the Ford Mustang GT 1996 Remanufactured Transmission provides exceptional mechanical stamina across aggressive road driving. This 4-Speed 2WD platform supports 215 continuous horsepower and 285 lb-ft torque at a 5500 RPM maximum engine speed. Calibrated hydraulic circuits maintain 195 PSI mainline fluid pressure to prevent internal friction plate slip under gross vehicle acceleration loads.

Enclosed in an A380 die-cast structural aluminum casing, this unit contains wide-ratio 8620 alloy steel planetary gearsets that stop tooth fracture under sudden load changes. Sintered bronze friction plates replace organic linings to resist high forward clutch heat. The remanufactured valve body includes hard-anodized aluminum bore sleeves plus an oversized steel pressure regulator spool. Total dry weight measures 205 lbs, holding 12 quarts of fluid through 3/8-inch inverted flare ports alongside a furnace-brazed lockup torque converter.

Key Features of Ford Mustang GT

Street drivers choose to buy Ford Mustang GT 1996 remanufactured transmission inventory for fast, crisp shifts and rock-solid reliability. This driveline maintains exceptional hydraulic pressure during aggressive street and track driving.

• 4-Speed wide-ratio gearsets provide extra mechanical leverage during highway acceleration
• Remanufactured 1996 Mustang GT valve body channels uniform line pressure without hydraulic bore wear
• 2 planetary gearsets disperse tooth contact pressure to resist fatigue fracture under load
• Precision balanced 1996 Mustang GT torque converter package prevents harmonic vibration at highway cruise
• Upgraded Viton fluid seal rings maintain tight hydraulic clamping pressure under high heat
• High-capacity overdrive bands eliminate friction slide under continuous expressway pulling
• Calibrated accumulator springs soften shift engagement impact without extending friction slide

Thermal Dynamics Gear Step Ratios

Operating line pressures remain constant between 175 and 210 PSI across all forward speeds. Transmission sump temperatures hold steady from 165°F to 195°F when routed through external chassis fluid coolers. The internal geartrain delivers smooth step ratios consisting of 2.84:1 in 1st gear, 1.55:1 in 2nd gear, 1.00:1 in 3rd gear, and 0.70:1 in 4th gear overdrive. The complete rotating gear group sustains 285 lb-ft continuous input torque at 3500 RPM, channeling excess heat straight into external frame-mounted cooling coils without internal fluid breakdown.

Driveline Mount Spline Alignment

A precision-machined 28-spline output shaft interfaces straight with slip yokes to drive rear differential axles. Front bell housing pilot register measures 5.000 inches to secure true concentric engine block mating. Distance from bell housing face to crossmember mount measures 24.8 inches, while total output bushing dial runout remains under 0.0016 inches.

Dynamometer Calibration Maintenance Guidelines

Each completed unit undergoes full computer-controlled dynamometer runs under high payload resistance to verify shift solenoid actuation, mainline line pressure rise, and lockup clutch engagement. Automated fluid diagnostic sensors inspect cooler line flow rates and port pressures prior to crate shipping. This unit is not engineered for modified sled-pulling trucks, uncalibrated drag racing, or installations retaining contaminated transmission oil coolers.

• Inspect fluid level on level ground every 14 operating days
• Drain fluid and replace bottom pan filter every 25,000 miles
• Inspect transmission crossmember mount bolts every 12 months

Commercial Warranty Crate Package

Fleet buyers receive an extensive 3-Year unlimited mileage commercial warranty protecting transit investments against unexpected mechanical downtime on the job. The rugged wooden transport crate contains the complete remanufactured transmission, dyno-tested lockup torque converter, inline fluid filtration canister, vehicle installation guidelines, and fluid specification documentation tags.