Tohatsu MFS30DEFL 30HP 20in Standard Configuration Outboard Motor

Description

Eliminate manual tilt back strain using the Tohatsu MFS25DEFTS Marine Outboard Engine for harbor service. Built with an integrated power tilt unit and 15-inch shaft, this 500 cc D-Series three-cylinder powerhead generates 25 continuous horsepower at 5000 to 6000 RPM. Electronic fuel injection pairs with electric start on commercial work skiffs.

Engineers cast the lightweight D-Series three-cylinder block from marine grade aluminum alloy treated with anti-corrosion finishes. Centrifugal cast iron cylinder sleeves resist piston ring wear during continuous commercial operation. The 15-inch short shaft midsection houses an integrated electro-hydraulic power tilt actuator and stainless steel driveshaft. Base dry engine weight reaches 132 lbs without propeller. The internal wet sump stores 1.8 quarts of motor oil, monitored through an integrated oil inspection window.

Key Features of Tohatsu MFS25DEFTS

Commercial fleet owners buy Tohatsu MFS25DEFTS outboard engine units for high-thrust auxiliary propulsion on commercial work sailboats and tenders. Integrated electro-hydraulic power tilt allows operators to raise the lower unit from tiller controls.

• Electro-hydraulic power tilt mechanisms lift the lower unit out of the water with push-button tiller switches.
• 15-inch driveshaft configurations align with standard commercial dinghy and skiff transoms without brackets.
• Battery-less electronic fuel injection produces immediate engine starts without requiring a heavy battery.
• Electric key start systems pair with backup manual recoil cords for fail-safe starting assurance.
• 500 cc displacement D-Series three cylinder blocks generate massive torque with lowest-in-class dry weight.
• Ergonomic tiller handles integrate gear shifting, throttle grip friction, and stop buttons in reach.
• High thrust propellers swing broad blade surfaces for increased stopping control in reverse gear.

Thermodynamic Combustion Profile Thresholds

Thermostat regulators maintain coolant temperatures between 135°F and 155°F inside cooling jackets to eliminate salt buildup. Three cylinders operate at 9.5 to 1 compression to generate 25 continuous horsepower at 5500 RPM under commercial auxiliary duty ratings. Overhead cams produce strong low-end torque when pushing heavy equipment payloads against harbor currents. Specific fuel consumption averages 1.75 GPH under full load operation. Internal raw water channels route engine heat into through-propeller exhaust paths to protect internal components during long continuous shifts.

Transom Installation Interface Geometry

Through-hub exhaust pathways discharge spent combustion gases underwater behind the propeller blade pattern to lower deck noise. Heavy duty transom bracket pads bolt across standard 15-inch boat transoms with four stainless steel fasteners. Heavy elastomer isolation dampers decouple engine vibration from aluminum hulls. Integrated power tilt rams provide full transom travel clearance.

Harbor Shift Service Protocols

Integrated tiller controls actuate forward, neutral, and reverse gear engagement without binding. Operators monitor the cooling water telltale stream to verify raw water impeller suction before departure. This outboard motor is not engineered for lightweight racing hulls, surface mud drives, or vessels operating without clean raw water intake flow.

• Inspect raw water intake grates for weed blockages before each shift begins.
• Drain crankcase engine oil and replace lower gearcase lubricant every 100 hours.
• Replace engine spark plugs and inspect external zinc anodes every 12 months.

Commercial Warranty Crate Specifications

Tohatsu provides 3-year commercial or 5-year recreational limited factory warranty coverage on this marine powerhead. The export carton contains the complete MFS25DEFTS outboard motor, an external 6.6-gallon fuel tank with hose, battery connection cables, operator service manual binder, maintenance tool kit, and aluminum three blade propeller.