Yamaha F350XSA 350HP 25in DEC Standard Rotationin Gray Outboard Motor

Description

Command unmatched high-thrust acceleration with the Yamaha F350XSA DEC Outboard Motor platform for 25-inch transoms. This 4.3-liter V6 engine produces 350 horsepower at 6,000 RPM for modern offshore vessels. Digital electronic controls and integrated digital electric steering eliminate external steering pumps, while sequential multi-port electronic fuel injection regulates fuel delivery across turbulent open ocean swells.

Die-cast aluminum powerhead architecture incorporates plasma-fused cylinder walls to resist bore wear. The motor weighs 635 lbs without gearcase lubricant or propeller. Engine oil capacity spans 6.7 quarts within an internal aluminum sump. Raw seawater cooling passages feature specialized internal coatings and replaceable cupronickel sacrificial zinc plugs to prevent corrosion.

Key Features of Yamaha F350XSA

Marine builders buy Yamaha F350XSA outboard engine configurations to outfit integrated digital electric steering stations on deep-vee offshore hulls. Integrated steering cylinders eliminate hydraulic hoses in the transom splash well and deliver immediate rudder response.

• Integrated digital electric steering eliminates hydraulic lines, external fluid pumps, and bleeding procedures
• Digital electronic control integration eliminates mechanical friction across long helm control wire runs
• 4.3-liter big-bore V6 block generates substantial displacement torque to lift heavy rescue craft on plane
• Variable camshaft timing advances intake timing to generate instantaneous low-end acceleration under load
• High-output 70-amp alternator delivers stable electrical current to modern marine electronics suites
• Plasma-fused sleeveless cylinder walls double surface hardness while reducing friction to extend engine life
• Integrated Yamaha F350XSA sensors transmit engine speed, fuel flow, and diagnostic codes to helm monitors
• Corrosion-resistant propeller shaft provides secure spline mounting for high-thrust stainless propellers

Combustion Profile Thermal Thresholds

Precision fuel calibration maps maintain cylinder operating temperatures between 140°F and 160°F across full throttle sweeps. The V6 engine generates 350 brake horsepower with continuous RPM ratings up to 6,000 RPM. Fuel burn records 13.5 GPH at 4,000 RPM cruise, rising to 31.0 GPH at wide-open throttle. Integrated knock sensors retard spark advance when thermal sensors register temperature creep, preserving combustion integrity.

Transom Clearance Bracket Geometry

Engine mounts bolt straight to 25-inch commercial transoms built to ABYC marine dimensional standards. Multi-position bracket hole patterns allow shipyard technicians to tune propeller depth relative to the hull keel. Trim cylinders deliver minus-4 to plus-16 degrees of running angle, while full tilt reaches 67 degrees to elevate the gearcase clear of salt spray.

Shift Protocol Operational Limits

Drive-by-wire electronic shift solenoids engage forward and reverse smoothly without gear case chatter. This engine is not engineered for hydroplane surface racing, raw swamp mud running, or continuous unmonitored commercial towline operations. Strict scheduled maintenance prevents mechanical degradation across continuous marine shift cycles.

• Check lower unit oil condition and verify unobstructed telltale water flow each shift
• Change engine oil, replace primary fuel separator, and install new oil filter every 100 hours
• Replace lower unit rubber water pump impeller and zinc anodes every 12 months

Factory Warranty Crate Contents

The unit carries Yamaha protection under a 1-Year commercial or 3-Year recreational limited warranty. The wooden shipping container holds the 25-inch digital outboard motor, digital command link harness, transom fastener pack, zinc anode set, and official owner operating manuals.